Denon DSB-150 Bedienungshandbuch PDF herunterladen (Seite 8)

Connecting Headphones

Connect the headphone plug to the 3.5mm jack beside the symbol. This turns oﬀ the DSB-150

internal speakers. If your headphones have a larger 1/4-inch plug you will need an adapter, available at

many retailers.

Auxiliary Input

Press the button on the top or on the remote control. The button on

the top will light blue.

The DSB-150 can accept an analog signal from a wide range of sources—

from CD players to MP3 players, and even older legacy devices. You’ll need

a cable with a standard 3.5mm stereo mini plug to connect between the

source and the auxiliary input on the left side of the system.

Note: The analog output signals from some sources can be fairly strong. If the volume level of the

source device is turned up too high, it could overload the inputs of the DSB-150. This is unlikely to cause

damage, but can cause distorted sound. Initially, set the volume of the source to a medium – low level,

then turn it up as needed. If you hear distortion, turn down the device’s volume control.

Wall Mounting the DSB-150

The DSB-150 can be wall mounted using the

keyhole openings on the back of the system.

Install two M5 or equivalent screws in the wall.

They must be exactly 3

/16” (100mm) apart, and

level with each other. Leave about

/16” (5mm)

of the screw shaft exposed so the head of the

screw can engage the keyhole opening. Carefully

position the DSB-150 keyhole openings over the

screw head and set it in place. Be sure the cabinet

is ﬁ rmly mounted on the screw heads before you

let go of the system.

/16 in

(100mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Keine Kommentare

Denon DSB-150 Bedienungshandbuch Seite 8